Cross-flow cooling tower Introduction This series of cross-flow cooling tower using both sides of the inlet, near the top of the fan, the air through the tower on both sides of the filler, with hot water and media exchange, humid air is then discharged to the outside of the tower. Fillers (both sides) with a point-wave plate bump, the mounting head by the point-wave plate bonded into a whole, in order to increase rigidity, both sides of the bump can avoid direct drip, thus increasing the water film forming ability, the filler has a closed end water measure. Product Features: 1, space-saving construction, lightweight series of cooling towers used exclusively for the purposes of efficient heat exchange packing design, the heat transfer area greatly improved, with the original series and original HBLCD HBLD series compared to its large footprint decline, due to structural design optimization and the use of steel, running weight is also greatly reduced. 2, save electricity using small ventilation resistance fillers and by Tsinghua University designed specifically for cooling tower wing FRP high efficiency fans, thereby reducing the equipped with the motor power, ultra-low noise type with motor power smaller, more economical electricity, but also according to the user's requirements, equipped with two-speed motor to save power. Please login www.dgenzen.com www.dgjinquan.cn